Guide :Radio Communications : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio

Scematic need F235 Resister crossrefernce and or value and location on circuit board.Glass encase 4mm redish orange, black end.

Posted by KENNETH NANYS on Jul 07, 2007

Suggested Questions And Answer :


Scematic need F235 Resister crossrefernce and or value and location on circuit board.Glass encase 4mm redish orange, black end.


Your description of "Glass encase 4mm reddish orange, black end." leads me to deduct that this is a diode. The black end denotes the cathode. For more help, post back.
Read More At : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio...

Cobra MicroTalk PR-3550WX - Static after transmission


Dear sir, try to operate ur radio in different channel ,( ur operating area seems to be have so dense radio smog ..if u are located near some border where ur adjacent frequency is in use this cud be the problem . first try in low power channel ( 8-14) ..if it solves ur problem ok ur u try to contact ur seller , & get it replaced if its under warrenty period. Regards raj
Read More At : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio...

Cb radio installation


You can Go with what you have PlEASE RATE My ANSWER
Read More At : 18 WX ST II 40-Channels Base CB Radio...

Galaxy 2547 off frequency


1 one thousandth of a number and you are worried. now if it said 27.18350 instead of 27.1850 then you would be off frequency.but for that little bit its not even a problem
Read More At : DX-2547 40-Channels Base CB Radio...

Do you a a manual for my motorola talkabout 250 free to print? has: scan, lock, code, monitor to it. Also orange button for turning on, push to talk features blue face, black body battery cover short antenna about 2inches high probably total approx 6 to 7 inches high including the antenna. iceberg5252@yahoo.com Thank You for your time, Mr.Richard Berg


We haven't located the TalkAbout 250 manual online. However, here is a link to the similar TalkAbout 280 user guide, it may help, http://www.giantintl.com/ContentManage/manuals/Moto/T280_User_Manual.pdf Best regards.
Read More At : Talkabout FRS 250 (14 Channels) 2-Way Radio...

Cobra Microtalk PR 240-2 Radios. One of the radios transmits on a frequency that is one less than the displayed channel, that is, when channel 9 is displayed, the radio transmits on a frequency of 467.5625 MHz, which is actually channel 8. This is true for all channels. The frequency is always off by one channel. This was confirmed by using a frequency scanner. Can this be easily corrected?


Very interesting, what happens if you turn it to channel 1? What channel is it on?
Read More At : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio...

About motorola t5720


Hello, Thanks for requst me, As far as I understood, you have same settings in both radios, you mentined QT this is the 3° requirment to recive a signal, 1° channel, 2° subchannel (ctcss, pl, etc) and the 3° QT. if you are using QT you must to send a Call from the other radio, I recomed to set the QT to Off in both radios and tray if you can communicate in both directions. if does not receive, there is the possibility that one of your radios the Sub channel decoder is not working. If you could test your radios with a Third radio to know wich radio is not working right. Good luck
Read More At : Talkabout T5720 (7 Channels) 2-Way Radio...

Brand New Cobra microtalk won't work!


I had to replace some of the cheap Chinese NiCad batteries to get mine to work. Check them all with a voltmeter, they should be at least 1.1 volts DC.
Read More At : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio...

Audiovox 2 way family radio charger (for 4 radios). Plug in RV and no lights displayed indication it's charging. Remove inline fuse and it's ok. Put fuse back in and orange lights come on indicating it's charging but stay on only a few seconds and go out. Remove fuse, put it back in and again lights are on for a few seconds and go out. Left RV plugged in for several hours and radios never charged. Audiovox 2 way family radio charger in RV. FRS4WM ser#103100497


It sounds like you have some corrosion on the terminals. Remove the batteries and with a good light source look at the springs and plates to make sure there is no corrosion. If there is remove it with crocus cloth. Check the batteries also for corrosion. If you find any remove it the same way. If after cleaning everything the batteries still will not charge get new ones as you probably have one or more which are shorted. Thanks for using FixYa and for the generous rating. hardrocko
Read More At : 2-Way 14 channel FRS Family Radio Walkie Talkie 2 Mile......

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || radiocomunicate.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1744 seconds