Guide :Radio Communications : 1001Z 40-Channels Base CB Radio

"squeak" when transmitting

Everytime I transmit with my Midland, there's like a squeak over my voice, like "squueeeeeee" everytime I try to talk. My friend just got the same radio and has the same problem but worse. Sometimes I can't hear a word he says because of this noise. A trucker said to adjust the gain, but there is no gain on this radio. For some reason, I think it has to do with the mic because it only occurs when trasmitting, but then again it could have to do with some kind of interference in my car. I got my Midland-1001z from Amazon with an Antenna from there too: http://www.amazon.com/Cobra-HG-A1000

Research, Knowledge and Information :


'Squeak' From Automatic Transmission (best, filter, mechanic ...


Jan 21, 2010 · 'Squeak' From Automatic Transmission (best, filter, mechanic, car) User Name: ... Do you prefer Manual or Automatic Transmission?, Automotive, 387 replies
Read More At : www.city-data.com...

Squealing on transmit | Clays Radio Shop Blog


Mar 04, 2012 · There are two distinct types of squeals. An audio feedback and an RF squeal or hum. An audio feedback (squeal) is caused when the speaker is located to ...
Read More At : htmcnetworkcitizensband.wordpress.com...

Headset Feedback Squeal | Pilots of America


Headset Feedback Squeal. ... I've gotten a loud feedback squeal when I engaged the PTT button on the ... Then it feedsback through the com I'm not transmitting on, ...
Read More At : www.pilotsofamerica.com...

high pitched squeal when transmitting - wmi.org


high pitched squeal when transmitting ... I've got an Apelco 25W VHF radio in which has a high pitched whine or squeal when transmitting.
Read More At : www.wmi.org...

Squealing..manual transmission..I release the clutch..fluid ...


Suddenly heard a squealing/screeching noise when I put my manual transmission car into gear. Seems to be when I release the clutch or just thereafter then it's o.k.
Read More At : www.justanswer.com...

Squeak in transmission - Ford F150 Forum


Squeak in transmission. 6 posts • Page 1 of 1. Twiggy1o3 New Member ... Jim1205 wrote:Are you sure it's the transmission? I just had a squeak that sounded like ...
Read More At : www.fordf150.net...

Transmission squeak - YouTube


Aug 02, 2012 · Transmission squeak gameover9191. Loading... Unsubscribe from gameover9191? ... 2012 Subaru Legacy Transmission Squeal / Squeak. - Duration: 0:22.

automatic transmission squeak - Mercedes-Benz Forum


Gorilla, Transmission don't squeak. You have some worn bushing somewhere in the drivetrain/suspension system. I'd start by inspecting the sway bar bushings.
Read More At : www.benzworld.org...

Suggested Questions And Answer :


"squeak" when transmitting


First off, are you using the stock Midland mic, or are you using a new mic. Midland mics are wired different than Cobra and Uniden Mics. You can check this by reading between the pins on the 4 pin connector with a meter. Check for continuity between pins 1 & 3 for Cobra and Pinss 2 & 4 for Midland while pressing the mic switch. To change between the two configurations, swap pins 1 & 2, and 3 & 4. By the way, the only relation between the length of coax and swr is just what the reading you see on an inline swr meter. You can only adjust the actual swr by adjusting the antenna itself. If you need instructions for setting your swr, lmk and I will post them. Dean Rollin CBs Mt. Vernon, TX
Read More At : 1001Z 40-Channels Base CB Radio...

Transmitting Squeal I receive signals very crisp and clear on all channels. However when I key the mic, whoever is receiving my signal, hears a very loud mono tone squeal. None of the controls have any affect on the noise, yet when I move the mic around in the cabin, the squeal changes tone. Also when I wrap my hand around the mic cord at the top where the coils begin, the squeal goes away, the digital power meter goes into the red, and I transmit just fine. I am using: New Midland 1001Z radio, original stock mic that came with the unit, 3 ft adjustable Firestik antenna and a Hood Channel Mount kit that includes 18 feet of Fire-Flex coaxial cable with the Fire-Ring connector. I have the power connected to the fuse block under the hood and ran through the firewall using the supplied rubber grommet. I kept the ground wire short and found a nice ground near the steering arm. I have heard that shortening the coax cable affects the whole system so I kept it at the stock length. However since I am short on room, the excess slack is coiled up and stored behind a dash panel. My guess for my problem is either the coiled up coax, the coax running along the hood channel, or bad grounding. If it is a bad ground, how would I check for a solid ground? Also the antenna and mounting kit does not mention anything about grounding the antenna, do I need to do that with my set up? (See picture above) If so, how? Thanks for your help!


Power right off the battery
Read More At : 1001Z 40-Channels Base CB Radio...

CB Squeal When Transmitting


Try changing you mic and also keep it away from your external speaker if you have one. There are ways to cure this symptom and they are inexpensive and you can do it.
Read More At : 1001Z 40-Channels Base CB Radio...

CB Squeal When Transmitting


I believe the coiled coax may indeed be the problem. To check, try a temporary rerouting of the cable which eliminates the coils. Dave g.
Read More At : DX-44V 40-Channels Base CB Radio...

High pitched squeal when trying to transmit - Midland 1001Z 40-Channels Base CB Radio


What mic are you using for this. It won't take just any mic. It has to be wired midland.
Read More At : 1001Z 40-Channels Base CB Radio...

I can't transmit, but I can receive signals - Midland 1001Z 40-Channels Base CB Radio


Hi,my name is John. Start with checking your Squelch and RF GAIN wide open. Check that your antenna is grounded good and no metal objects are blocking it. Turn the MIC GAIN to MAX. Key the Mic, the needle should move or a light should come on. Try another MIC. if it doesnt. Let me know how it does, could be something internal that I can help you with.....hope this was very helpful...
Read More At : 1001Z 40-Channels Base CB Radio...

When i transmit it makes a noise - Midland 1001Z 40-Channels Base CB Radio


Is this a new radio? If not what kind of mic or you using. These want take just any mic.
Read More At : 1001Z 40-Channels Base CB Radio...

Hy, I've installed my midland 1001z on my car with a truth glass midland antenna, I live in DR once I turn on the radio it just does not receive anything, it shows that i can transmit but I don't receive anything can this be the crystal from the radio that it's not compatible for this country or something else? I'll really want to know because I've try everything and nothing seen to work. Thanks.


Hi May I ask if you checked the swr on the antenna or may be try another type of antenna.Ray
Read More At : 1001Z 40-Channels Base CB Radio...

Audio playback through speakers


HELLO This happens because of the close proximity of the CB transmitting antenna to the car stereo antenna. I don't know for sure what country you live in, but if your country's CB system uses AM as a transmission mode it is well known for breakthrough on audio systems etc. In the UK, we have FM on CB frequencies which is less-prone to giving interference. You could try ferrite rings/clamps on the car stereo antenna coax cable, power cable and also on your loudspeaker cables too. Apart from that - that is all you can do using it mobile! GOOD LUCK
Read More At : 1001Z 40-Channels Base CB Radio...

Midland squealing when talking


Soundwas keying up at the same time.s like it could be one of two problems. a loose wire in the mic or some one near you keyed up the same time as you. if the wire in the mic is loose sodder it. If some one keyed up near you you might have blown the reciever chip.
Read More At : 1001Z 40-Channels Base CB Radio...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || radiocomunicate.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1463 seconds