Guide :Radio Communications : H700 Wireless Headset

Putting it Back Together - 3mm pin inside the casing

The headset worked perfectly, but it recently fell off my ear on to the floor and stopped working. I noticed the casing actually came had come apart, it simply snaps together in two pieces. Nothing inside seems to be physically damaged, the lead wires are all intact, the buttons click when depressed and the light comes on when I plug it into the charger. However, opening the boom no longer turns the headset on. There is one piece that I cannot figure out what to do with, it is a small ~3mm long plastic gray offest pin one end of the pic is slightly thicker than the other. I am assuming it

Research, Knowledge and Information :


How to Install Baseboards (with Pictures) - wikiHow


How to Install Baseboards. ... but not always possible to add back on. ... buy the baseboards and bring them inside one week before installation to allow them to ...
Read More At : www.wikihow.com...

Backup of Backing and Binding Your Quilt - Anita Goodesign


Carefully pin all three layers together inside the quilt ... Remove the pins from the back as ... Backup_of_Backing and Binding Your Quilt
Read More At : www.anitagoodesignonline.com...

How To Install a Door - Bob Vila


How To: Install a New Door ... The jack plane will also trim it to fit and isn’t as ... Slide the bottom hinges together and put that pin in. Tap them both into ...
Read More At : www.bobvila.com...

MR2 door wiring fix How-To - Stephen Mason


MKII Toyota MR2 door wiring fix How-To guide. ... Putting everything back together. ... Put the door sill / kick panel trim back together and reattach the frunk latch.
Read More At : www.stephenmason.com...

Casing and tubing - PetroWiki


Liner is a casing string that does not extend back to the ... the neighboring joints together during axial ... of the fracture strength of the pin and the ...
Read More At : petrowiki.org...

How to Insert a Drawstring: 8 Steps (with Pictures) - wikiHow


Here is how to insert a drawstring ... seams in the casing, the pin will get caught under the edge of the seam allowance. Pull the safety pin back a little bit ...
Read More At : www.wikihow.com...

How Does Casing Work? | Rigzone


How Does Casing Work? ... casing is tubing that is set inside the ... that are usually about 40 feet long and screwed together to form longer lengths of casing, ...
Read More At : www.rigzone.com...

How to Install Wood Molding | The Family Handyman


How to Install Wood Molding. ... Back to Top Tip 3: Put the pinch ... They're perfect for holding small pieces of mitered trim together while the glue dries and for ...
Read More At : www.familyhandyman.com...

Fixing That Jet Lighter You Love: 7 Steps - Instructables


... Fixing That Jet Lighter You Love. ... Putting It Back Together . ... usually that is the only thing holding a lighter together, now pull the casing down off ...
Read More At : www.instructables.com...

How to Put the Door on a Whirlpool Super Capacity 465 ...


The hinges on a Whirlpool Super Capacity 465 Accubake oven attach to ... allow you to put the door back onto the hidden hinge pins after ... pins exist inside ...
Read More At : homeguides.sfgate.com...

Suggested Questions And Answer :


Putting it Back Together - 3mm pin inside the casing


Hey, whats going on man? yea, i just dropped my headset on the floor today too. the same thing that happened to you happened to me. well i think i found the solution. if you look at the headset from the bottom theres going to be an indent on the top left corner and underneath it theres going to be a little gold circle thats going to be split in four. thats where the little plastic peice goes, with the black side touching it.
Read More At : H700 Wireless Headset...

Phone wont detect bluetooth H700


Mine could be discovered when powered off/ on my cellphone and retried... Sounds like solution to M$ programs, eh? :)
Read More At : H700 Wireless Headset...

H700 / Samsung Blade: WILL pair. Won't Connect!


PUT HEADSET IN PAIRING MODE1. Ensure the headset is turned off (indicator light not blinking and headsetboom is closed)2. Press and hold the Call button. After about 4 or 5 seconds, the indicatorlight becomes steadily lit in magenta3. Release the Call button and immediately open the headset boom. Theindicator light remains lit in magenta.If the indicator light is flashing in blue or not steadily lit when opening theheadset boom, repeat steps 1 through 3 The
Read More At : H700 Wireless Headset...

Problems w/H700 bluetooth


Try taking a small needle and gently clearing out the mike hole near the end of the boom. Anything I am outside and sweating a lot mine will clog up and I have the same trouble until I clean it out and then it's fine. Do not insert the needle in very far, all you need is to clear the outside opening a bit.
Read More At : H700 Wireless Headset...

H700 unable to pair up 'service not supported'


I bouth motorola H700 bluetooth headset to use with my Razor (3rv) and I have followed all the rules of my razor to connect with my bluetooth. My Razor does recognize my bluetooth and the screen show that I am sucessfully linked together. However when I close my phone or anytime there after--open my bluetooth place on my ear and open my Razor to make a phone call my bluetooth is not connected. It will not make a call or let me hear dialing of numbers or anthing. I know that my bluetooth works, i just lost the directions on how to link it with my new razor. it was linked to my old razor, but i lost it and ever since I have had this new phone it does not work together. can you help me. I spent a lot of money on my bluetooth for it to just go to waste. Thanks very much, Angie
Read More At : H700 Wireless Headset...

Motorola H700 Problems with BB Pearl 8100


Steps to pair a H700 headset with any bleutooth pone: Make sure the H700 fully chared (very important)!! Make sure the microphone boom is folded closed, i.e. power is off! Hold the call button for 1-5 seconds until the light is steady lit purple Flip out the microphone boom, the light should stay lit purple! Now you are ready to pair the headset with your phone, so follow the pairing instructions of your phone. Note: When prompted for the Passkey; it is most likely 0000 but the correct Passkey should be on the headset accessory instructions. I must add that indeed my headset on occation (once or twice every three months) also loses its connection with the blackberry (a 8703e) . At which time I have to remove the headset from my phone bluetooth device list, and start the above described steps to pair my headset with the phone again.
Read More At : H700 Wireless Headset...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || radiocomunicate.net || Terms of Use || Contact || Privacy Policy
Load time: 0.1570 seconds