Guide :Radio Communications : HS820 Consumer Headset

Light stays on

The light stays on all the time until the battery dies. I can not make or receive calls with it. Like it is not on. I plug it in and the light stays on and when I unplug it it flashes off for a second and then turns back on. Normally when I plugged it in, the light would come on and stay on until it was fully charged then the light would shut off. It would flash intermitently while in use. But nothing happens when I push the button to turn it off/on. Is there something I can do? Is it beyond help? I bought it used, so I don't want to spend any money to fix it.

Research, Knowledge and Information :


What Causes the Brake Warning Light to Come On? | Angie's List


If your car's brake warning light comes on, you should have it checked out immediately. Here are a few reasons the brake light comes on.
Read More At : www.angieslist.com...

Parking brake light stays on Inspection Service & Cost ...


Parking brake light stays on Inspection costs between $70-$80 on average. Get an instant estimate for your car. Book a mobile mechanic, backed by warranty. Service at ...
Read More At : www.yourmechanic.com...

Brake Light Stays On - Problem in Chevy C1500 - ThoughtCo


Question: What Is Causing the Emergency Parking Brake Light to Stay On? I recently bought a 1991 Chevy C1500 with an automatic transmission and a 350 engine.
Read More At : www.thoughtco.com...

I have light that stays on even when the switch is turned off.


How JustAnswer Works: Ask an Expert ... but the light stays on constantly even without being connected to the switch as long as the breaker is on.
Read More At : www.justanswer.com...

3 Ways to Fix a Stuck Brake Light - wikiHow


Sep 02, 2016 · How to Fix a Stuck Brake Light. Your brake lights are an essential part of your braking system. Brake lights are intended to keep other drivers aware of ...
Read More At : www.wikihow.com...

electrical - Why is one light staying on when the switch is ...


Why is one light staying on when the switch is off? up vote 0 down vote favorite. ... Light bulb stays on regardless of switch position? Hot Network Questions
Read More At : diy.stackexchange.com...

Light will not Turn Off using light switch - Forum - Bob Vila


Light will not Turn Off using light switch. Tags: ... The light switch doesn't turn the light off and on. The light stays on all the time so I disconnected the ballast.
Read More At : www.bobvila.com...

What to Do When the SRS Light Stays On | My Auto Solutions ...


Find out what to do when your SRS light stays on. My Auto Solutions offers airbag module reset and repair services in the metro Atlanta, Georgia area.
Read More At : masrepair.com...

How to Respond When Your Car's Battery Light Goes On


How to Respond When Your Car's Battery Light Goes On. Your car's battery light is an indicator of when your car's charging system is malfunctioning. This can be a ...
Read More At : www.wikihow.com...

Brake Light Stays On | Fix My Hog


Q: I hope you can lead me in the right direction. I recently replace the throttle grip on my Heritage but now the brake light stays on and won’t disengage.
Read More At : www.fixmyhog.com...

Suggested Questions And Answer :


Hs820 light stays on


Same problem with mine... there is no solution for that, I've had the same problem a year ago... and it's a useless unit... there's no solution and there are a lot of Hs820 with this problem.... This headset is a piece of sh** !!
Read More At : HS820 Consumer Headset...

Motorola hs820 the light stays on after a charge. clicking and holding the call button for 3 seconds or even a minute doesn't turn the light off or take it out of pairing mode. it charged overnight and the light never turned off even after unplugging. is there a general reset button?


I am having the same proble too..I am going to open it up and see if I can fix it, I'll keep u guys posted... Blazemorefire..
Read More At : HS820 Consumer Headset...

After charging my HS820, the light stays on, no matter what I do, and it is supposed to be in sync mode, but it won't sync with my Samsung, but my other Motorola headsets do!


You need to disconnect it from the charger and keep the button pressed to put it in pairing mode, then associate with the phone with the PIN 0000.
Read More At : HS820 Consumer Headset...

Motorola Bluetooth HS850 Pairing Mode


Was soooo helpful just make sure u do flip it open immediately after, thats were i messed up... Thk
Read More At : HS850 Consumer Headset...

Motorola Bluetooth HS850 Pairing Mode


This worked great for me... I got the headset in "pairing" mode by following these instructions. Then set my BB Curve 8350i to "discover" bluetooth devices. It discovered the headset and asked for a PIN number... one of the other articles I read said the pin was "0000" so I put that in and - PRESTO - it works
Read More At : HS850 Consumer Headset...

HS850 Signal Light Wont stay on to be able to pair w/ V3 razr


When I paired my headset to my Blackberry - I had to do the following... Set my phone into the pairing mode.. quickly press button on HS850 and when blue light comes on, hold button and open boom - It has worked this way several times for me.
Read More At : HS850 Consumer Headset...

Light stays on


This sound like you have it constantly in pairing mode(this is when light is always on)
Read More At : HS820 Consumer Headset...

Trying to pair Motorola HS850 to cell but I hold down button and light comes on but won't stay on


You hold the button with the boom closed and as soon as the light stops blinking you realease the button and open the boom, the light should remain on and steady. promt your cell phone to find it and the code is 0000
Read More At : HS850 Consumer Headset...

Jabra bt250v Indicator light doesn't remain on...


I have just repaired my bt250 with this problem, i hadn't used it for around 2 years and when i put it on charge just got i flash of blue led. the fix was to "jumpstart it" the headset needs to se some sort of battery voltage to start the charging process, i stripped mine right down but that was just to fiddley. IF YOU DO THIS IT WILL BE ENTIRLEY AT YOUR OWN RISK AND I TAKE NO RESPONSIBILITY IF YOU TRASH YOUR OTHERWISE USELESS HEADSET. ok all you need to do is very carefully remove back cover (undo 1 screw and ease it apart). be very carefull as there are delicate wires inside. lift the inner part out slowly and you will see the battery.it has some orange tape around the end and there is a small circuit board attached to it with a small red wire and a small black wire. look at the battery and you will see under the orange tape there are to larger tags.these are the main battery terminals, peel back the orange tape just until the tags are slightly exposed. now you need to solder a wire to each of them and DON'T TOUCH THEM TOGETHER. on the battery it says which tag is + and which is - make sure you mark your wires or get red and black ones. now i used the lead from the charger. look at it . it has a hole in the center of the pin that is the + so put the + wire in there. if you are not sure use a volt meter. now touch the - wire to the outer metal of the connector that is the - point on the charger connector. hold this for around 2 mins but no more. as the out put of the connector is 6.2v and the battery is only 3.7v the battery will get warm. if the battery is getting too hot in under 2 mins then take of charge. when you have done that and taken off the connector i recommend to use a volt meter and just put it on the battery wires you soldered on to check battery voltage. as long as it reads you should be ok. de solder your wires from the tags and rebuild headset then try and charge it. this worked for me. i am no electronics expert i just like to mess with broken stuff so i know it seems a bit dodgy to connect like this but i had nothing to lose and it worked.
Read More At : BT250 Consumer Headset...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || radiocomunicate.net || Terms of Use || Contact || Privacy Policy
Load time: 0.0943 seconds