Guide :Radio Communications : 2231TE (22 Channels) 2-Way Radio

Neither Radio Transmits or Recieves

I'm about to move and wanted to use the rados for the long trip because of bad cell phone reception on the highway, however neither radio will transmit or recieve anything. The radios still make noise when the buttons are pressed but I'm having no luck getting them to transmit out or recieve. I'll press the PTT but the other radio won't recieve. It's the same with the other radio too. Also - on one radio there is a little red light that comes on (I'm assuming to let me know the microphone is active) but it only applies to one radio and not the other. Are these radios worthless? Or am I ov

Research, Knowledge and Information :

Debugging Radio Transmit / Receive - NXP Semiconductors

Kinetis KW2x - Debugging Radio Transmit / Receive. ... The radio hardware design is exactly the same as the TWR's. ... it neither receives nor transmits, ...
Read More At :

Transmitter - Wikipedia

In electronics and telecommunications a transmitter or radio ... the received waves. A practical radio transmitter ... transmitter, which transmits ...
Read More At :

Transmitter - definition of transmitter by The Free Dictionary

... or a person who transmits. a radio transmitter. Want to thank ... and while Bell went to the transmitter, Dom Pedro took up the receiver and ...
Read More At :

Diagnosing VHF Marine Band Radio Communication Problems ...

Diagnosing VHF Marine Band Radio ... We assume that B's radio works perfectly on transmit and receive. ... Now if A transmits and neither B or C can ...
Read More At :

RADIO -- Crossword entry | Crossword Nexus

RADIO Radio Radio is the wireless ... (receive) the signal sent over radio waves and render the modulated signal as sound. A device that can transmit radio signals.
Read More At :

Radio receiver - Wikipedia

In consumer electronics, the terms radio and radio receiver are often used specifically for receivers designed to reproduce ... (AM) to transmit sound by radio ...
Read More At :

TR1 - Transmit / Receive Sequencer

The TR1 transmit / receive sequencer is designed to allow the smooth operation of amateur radio stations where ... the TR1 will begin the transmit enable sequence.
Read More At :

CB will transmit but no receive -

Jul 19, 2007 · CB will transmit but no receive. Testing my buddy's CB I figured out that my CB will transmit but not receive. ... Time for a new radio or any other ideas ...
Read More At :

ARRL Amateur Radio Education & Technology Program

In a home amateur radio station, a transmit/receive ... transmitters and receivers are connected to antennas to either send or receive radio signals in a
Read More At :

Suggested Questions And Answer :

Neither Radio Transmits or Recieves

Have you checked that both radios are in the same Channel and the same Squelch Code? are the batteries ok? any rust in the battery contacts? Some FRS radios gets a Malfuntion, and the syntom is like that, check this first
Read More At : 2231TE (22 Channels) 2-Way Radio...

Talkabout MH230R does not Receive or Transmit on channel, can just Transmit (only clicks when Recieve) when programmed 2 channels higher (i.e. all radios on 5-3, one is on 7-3)

Strange. Could it be any of the radios are from different countries? The channels are not worldwide. For instance, Canadian radios are on different frequencies than USA radios. They look identical.
Read More At : Talkabout MH230R 2 Way Radio...

Motorola Talkabout FV700 not transmitting nor receiving

Had the same problem...took out nimh...replaced with triple great!!Thank you!!
Read More At : Radio Communications...

Not able to transmit or recieve on cb radio in car

Its a broken connection in the antenna coax :(
Read More At : Maxon...

Cobra 148 gtl new model

Hello bluzfan, Do you remember the old 40 channel CBs? they used basic A3A transmission (dual sideband single carrier)remember how you got crosstalk sometimes, if your power was too high? Then they went to 80 channel CBs (using a single side band as Lower Side Band (lsb) and the other as the upper side band (usb))? more crosstalk but they invented anl (automatic noise limiter)circuitry to compensate. Now you have the 120 channel CB which uses a form of side band multiplexing (20QAM) to generate 3 times more channel density 40 X 3 = 120. Here is my problem; Cobra should not have done this because you will have massive crosstalk and unaudible sounds because of the increase in channels but not an increase in initial (physical)bandwidth. I hate to tell you this but the only cure for the is to use it in 40 channel or 80 channel mode forget the 120 channel mode, or get a radio with better channel separation.
Read More At : 148 GTL 120-Channels Base CB Radio...

Neither radio will receive or send

The radio probably needs reprogrammed to match the other units. Check your owners manual for instructions.
Read More At : Talkabout FR50 (14 Channels) 2-Way Radio...

Cobra 148 gtl

Open the radio up and find the L22 Can/Pot. It's the one with the wire soldered on top. With both fine and coarse Claifier/Voice Locks in the 12 O'Clock positions, confirm, then listen for someone that is on the correct frequency and turn this pot (small ferrite core inside) with a small plastic preferred screwdriver, until they sound clear. Do this for USB as well except, the Can/Pot is L59. Don't adjust the VR5 (transmit) unless you need to.
Read More At : 148 GTL 120-Channels Base CB Radio...

Brand New Cobra microtalk won't work!

I had to replace some of the cheap Chinese NiCad batteries to get mine to work. Check them all with a voltmeter, they should be at least 1.1 volts DC.
Read More At : MicroTalk PR 1100 WX (15 Channels) 2-Way Radio...

T8500 no recieve transmit vibrates when PPP is pressed

Try using a new set of Alkanie Batteries, if it Work your battery Pack KEBT-071 is broken, got charge memory problem you have to reset the charge cycle or buy a new one. And remeber Always tun off radios before charging.
Read More At : T8500 Two Way Radio...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.1465 seconds